Cayo Expert- "Loose" Headset
SwimminTukker
Posts: 38
in General Chat
Hi All - just received my new Focus Cayo Expert from a German dealer (Wiggle did not have my size), which I had to partially re-assemble. I have not ridden it yet, but have noticed that there is a significant amount of "play" in the front section, when I rock the bike back and forth, whilst holding the front brake locked. Also, when turning the handlebars from side to side, it amount feels and sounds a bit like "metal on metal", where the front tube goes into the fork area. Any suggestions, simply needs some lube and adjustments of the headset screws??[8|][8|]
0
Comments
- loosen off the bolt/s that attach the stem to the steerer tube (tube on top of forks).
- Now tighten up the top cap - the cap that sits on top of the steerer tube. Don't overtighten, just nip it up. You are just trying to tighten it enough to take the play out of the bearing but not overload it. Either put front brake on and rock bike back and fwd to see if it is tight enough or grab underside of fork and top of steerer to look for play.
- Once bearing is suitably tight, tighten the stem bolts back up again, this time give them a little bit more. These bolts will keep the whole lot in place.
that should be that! Hope this isn't too patronising. I don't know how much you know so thought I'd just take it from basics. Also had to rush cos at work!
A good source of reference is the Park Tools website, any further probs post up.